User's Manual

ManualsBrandsMikrotikls ManualsElectronicsUnlicensed National Information Infrastructure TX

R11e-5HacT

The R11e-5HacT is a miniPCIe format wireless interface that can operate in the 5GHz wireless spectrum. The card features

three MMCX antenna connectors.

Assembly and mounting

The card is a mini PCIe full length format. Unplug the host device from power, and remove the preinstalled screws from the two

locations where the card will be inserted. Insert the card at a slight angle, with the connector end first, push it slightly, so that it

clicks into place. Lower the card until it is parallel to the motherboard and then use the two screws to fasten it in place. Attach the

antenna to the card antenna connectors.

Configuration

The device will be automatically recognized when used in a RouterOS powered device. Configuration can be set in the

“Wireless” menu. More information about using RouterOS can be found in our documentation: http://mt.lv/help

Operating system support

The device is tested with RouterOS v6 and above. It might be compatible with other operating systems, but drivers are not

included with the card.

See www.mikrotik.com for more information or contact support@mikrotik.com 23-Nov-17 .

Summary of content (5 pages)

PAGE 1
R11e-5HacT The R11e-5HacT is a miniPCIe format wireless interface that can operate in the 5GHz wireless spectrum. The card features three MMCX antenna connectors. Assembly and mounting The card is a mini PCIe full length format. Unplug the host device from power, and remove the preinstalled screws from the two locations where the card will be inserted. Insert the card at a slight angle, with the connector end first, push it slightly, so that it clicks into place.
PAGE 2
Federal Communication Commission Interference Statement (FCC ID: TV7R11E5HACT) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
OEM statement. This module is intended for OEM installations only. As such the OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove install or modify the module. This module is limited to installations in mobile or fixed applications. OEM integrators may utilize antennas of like an equal or lesser gain as appearing in the list in this document (reference 47 CFR, paragraph 15.204(c)(4) for further information on this topic.
PAGE 4
Industry Canada (IC:7442A-R11E5HACT) This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
PAGE 5
See www.routerboard.com for more information. Contact support@mikrotik.