User's Manual

See www.routerboard.com for more information. Contact [e-mail] for support questions. 16-Oct-2012
RouterBOARD 951G-2HnD
Quick Setup Guide and Warranty
Information
Connecting
1. Connect your Internet cable to port 1,
and LAN computers to ports 2-5
2. Set LAN computer IP configuration to automatic (DHCP)
3. Wireless AP mode is enabled by default, you can connect to the
SSID “MikroTik”. Log into your router from your web browser
by opening 192.168.88.1 in the address bar
Powering
The device accepts powering from the power jack or from the first Ethernet port (Passive PoE):
 DC power jack (5.5mm outside and 2mm inside diameter, female, pin positive plug) accepts 8-30V DC
 The first Ethernet port accepts passive Power over Ethernet accepts 8-30V DC
Under maximum load, the power consumption of this device is 7W
Booting process
The device is preinstalled with MikroTik RouterOS software. It can be configured in several ways.
This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the Ethernet cable.
Connect to wireless SSID “MikroTik” and open 192.168.88.1 in your web browser. Username is admin and there is no password.
In case IP connection is not available, Winbox can be used to connect to the MAC address of the device. More information here:
http://wiki.mikrotik.com/wiki/First_time_startup
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the device
when starting it until the LED light turns off, and Metal will start to look for Netinstall servers.
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the device
when starting it until the LED light turns off, then release the button and the device will start looking for Netinstall servers.
By default, the device is preconfigured with a simple firewall on the WAN port, this configuration can be viewed when first
connecting to the Router via Winbox. It will ask whether to keep this configuration or clean it to use your own. LAN/WLAN
ports have DHCP server enabled.
Extension Slots and Ports
 Five individual 10/100/1000 Gigabit Ethernet ports, supporting automatic cross/straight cable connection (Auto MDI/X), so you can
use either straight or cross-over cables for connecting to other network devices. The First Ethernet port accepts 8-30V DC powering
from a passive PoE injector.
 One Integrated Wireless 2.4GHz 802.11b/g/n 2x2 MIMO, Onboard PIF antennas, max gain 2.5dBi
 One USB 2.0 port