Instruction manual

1.4 Warranty Note
Do not open the body of the camera. The warranty becomes void if the camera body is opened.
1.5 Remarks, Warnings
This document contains important remarks and warnings. See the corresponding symbols:

Important remark

Attention, Warning
1.6 The rear of the camera
The type plate is to be found at the rear of the camera. It contains the serial number.
There are two connectors for the Camera Link cables and one connector for the power cable. Make sure
that both Camera Link cables are connected according to their marking with the connectors on the cam-
era and the Inspecta-5 frame grabber.
(Connecter marking “BASE” on the camera must be connected to CHANNEL-0 on the grabber.)
The rear color LEDs of the MC131x camera shows the actual operating condition. Orange is shown
after power up, while the cameras self-test is in progress and will then change to green.
1.7 Scope of delivery
The following components are included as part of the delivery
- 1 MC130x (Base CL) or 1 MC131x (Full CL)
- 2 Camera Link ® cables and one power cable, 3m long
- 1 Inspecta-5 PCI-X frame grabber with 1GB local memory.
- 1 CD with MotionBLITZ®Kit operating software(MotionBLITZ®Director)
Inspecta-5 holds 1 Gbyte internal frame memory. From this memory, a very small part (only as much as
required by one frame) is used for storing the frames for the live mode. All of the remaining memory is
used for sequence recording.
MotionBLITZ®Kit Manual Ver.2.0 7