User Guide

Routing
59
Figure 26: Routing Screen
Data - Routing Screen
RIP
Enable RIP
Check this to enable the RIP (Routing Information Protocol) feature of
the Wireless Gateway.
The Wireless Gateway supports RIP 1 only.
Static Routing Table
Select Entry
This drop-down list shows all entries in the Routing Table.
• To view or change an entry, select it, then click the Get Data button.
• After making any required changes, click the Update button to save
your changes.
Destination
IP Address
The network address of the remote LAN segment.
For standard class "C" LANs, the network address is the first 3 fields of
this Destination IP Address. The 4
th
(last) field can be left at 0.
Network Mask
The Network Mask used on the remote LAN segment. For class "C"
networks, the standard Network Mask is 255.255.255.0
Gateway
IP Address
The IP Address of the Gateway on the LAN segment to which this device
is attached. (NOT the router on the remote LAN segment.)
Interface
Select the appropriate interface - LAN (Internal LAN) or WAN (External
LAN or WAN) from the drop-down list.
Metric
The number of routers which must be traversed to reach the remote LAN
segment. The default value is 1.
Buttons
Clear Form
Clears all data, ready for input of a new entry.
Add
Add a new entry to the Routing table, using the data shown on screen.
The name shown in the drop-down list is ignored.