User guide

10
DIP-switch
The DIP-switch is used to configure operation mode for LLF (Link Lost Forwarding)
and operation mode for Copper/Fiber port. The default value of Dipswitch is OFF.
 10/100/1000Base-T to 1000Base-FX converter module
S/W No Status Description
ON LLF Enable
1
OFF LLF Disable
ON Pure converter mode
2
OFF Switch converter mode
ON Reserved
3
OFF Reserved
Link Lost Forwarding: When LLF is enabled, it will allow copper port link failure to be
reported to the Fiber side and also allow Fiber link failure to be reported to the copper
side. Therefore, a link loss forward feature is provided in both copper and Fiber side.
Pure Converter mode: When pure converter mode is enabling (on), it operates with
the minimum latency. The transmission flow does not wait until entire frame is ready,
but instead it forwards the received data immediately after the data being received.
And TP port should be forced at 1000M in this application. When DIP-Switch is in
Switch Converter mode (off), the converter function is same as Switch Hub.
[Note]
a) Please don’t change the DIP-switch setting when copper or fiber port is transmitting
or receiving data. It may cause some data error.
b) Please power off then power on when you change the DIP-switch setting.