User guide

100
Low Queue Max Delay Time:
Set the time that low priority packets are queued
in the switch. The valid range is 0 to 255 ms. Since the default is OFF, the Max
Delay Time is 0. This item must be set if “Low Queue Delay Bound” is
enabled.
NOTE:
“Max bridge transmit delay bound control” must be enabled before Low
Queue Max Delay Bound is enabled.
6-3-8-4. Collision Retry Forever
Collisions Retry Forever:
User can choose to disable collision retry forever and, if a
collision occurs in half-duplex mode, the switch will attempt to send the packet 48
times and then drop the frame. When enabled, a collision that occurs in half-duplex
mode will result in repeated attempts by the switch forever.
6-3-8-5. Hash Algorithm
This Hash Algorithm is for hardware maintenance on the MAC table calculation.
This field should only be changed if an excessive amount of MAC address table
collisions are seen. It changes the hashing algorithm for storing new MAC
addresses in local memory.
6-3-8-6. IFG Compensation
IFG compensation:
Disable or Enable
Provides the ability to compensate for shorter inter-frame gaps during rate
limiting. It is recommended that this selection remain disabled.
6-3-8-7. IP Stacking Group ID (0…65535)
Assign a stacking group ID for the switch by entering a value between 0 and