User's Manual

Chapter Two - 14
OperatingInformation
Working with Power Button (Heater Kit)
Your tablet computer is equipped with a heater kit to enable work under low temperature.
The heater will heat up the HDD to the temperature set by the user before booting the
system. Also, the heater will constantly monitor HDD temperature. Once the temperature
becomes lower, the heater will heat up again to maintain the temperature set by user.
Note:
 When ambient temperature is under +5 °C (the default setting for your tablet computer),
the system may not boot up immediately. System will beep with HDD LED light flashing
orange to indicate that the heater is in operation. The LED will blink faster as the HDD
temperature approaches operational temperature. After 5~15 minutes, the system will
boot up automatically.
 In emergency situations, you can skip the heating process by pressing and holding the
power button for 9~11 seconds then release. The speaker will beep with a special
sound to signify that the heating process has been skipped (Please note that not all
devices are guaranteed to work properly in this case).
 Press the power button again during the heating process will shut down the computer.
The following is a list of functions associated with your tablet computer’s power button:
1. Press and hold for 12 seconds, then release:
USB port is enabled and you can set a new value in Heater AP.
2. Press and hold for 9 ~ 11 seconds:
The system will skip heating process and force boot up.
3. Press and hold for 5 ~ 8 seconds:
Enable/Disable the sound of Heater.
4. Press and hold the power button for 4 seconds under OS:
Shut down the system.
5. Press the power button:
a. Power on the system.
b. Force Shut Down (If pressed while the heating process is underway).
c. Sleep/Hibernate (Dependent on OS settings).