User Manual

Chapter One - 2
Getting Started
Quick Operation
z Loosen the battery screw, remove the battery insulation sheet, and mount
the battery.
z Connect the AC adapter with the computer and start charging the battery
for at least 10 minutes.
z Turn ON the computer by pressing the power switch.
Notice:
z When ambient temperature is under +5℃ (This is the default setting for
this computer.), the system may not boot up immediately. System will
beep with LED heater light flashing to remind the user while heater
working. Also, the frequency of the LED will become faster to remind the
user while the temperature is approaching to be suitable. After 5~15
minutes, the system will boot up automatically.
z Under an emergency situation, it is able to skip heating for booting up the
system immediately by pressing the power switch for >9 seconds. The
speaker will also beep with a special sound. (It is not guaranteed all
devices on the computer are possible to work properly.)
z Press the power switch again during the heating process will shut down
the computer.
z Driver or application installation may be necessary for further operation.
z The following procedures will help to Turn OFF the computer:
1. Press power switch to “Shut Down”, “Sleep”* or “Hibernate”*
depending on operating system (OS) and power management
settings.
2. Press power switch for 4 seconds for a “Hard” power off. But, note
that the system will shut down immediately without saving any data or
parameters.
3. Click Start → Shut Down in Windows to Turn OFF.
Note:
¾ Some operating systems may not support the above-mentioned functions.