SDS

Page | 4
7. HANDLING AND STORAGE
HANDLING (PERSONNEL):
DO NOT PRESSURIZE, CUT, WELD, BRAZE, SOLDER, DRILL, GRIND, OR EXPOSE SUCH
CONTAINERS TO HEAT, FLAME, SPARKS, STATIC ELECTRICITY, OR OTHER SOURCES OF
IGNITION; THEY MAY EXPLODE AND CAUSE INJURY OR DEATH.
Empty drums should be completely drained, properly bunged, and promptly
returned to a drum reconditioner, or properly disposed of. Wash hands
thoroughly after handling.
HANDLING (PHYSICAL ASPECTS):
Secure container after each use. Store in a cool dry area.
Avoid contact with strong oxidizing agents.
STORAGE PRECAUTIONS:
Store in a cool dry place, in a tightly closed container. Eliminate all sources
of ignition - heat, sparks, flame, electricity, impact and friction.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
ENGINEERING CONTROLS:
Local exhaust ventilation may be necessary to control any air contaminants to
within their TLVs during the use of this product. TLV for mineral oil is 5 mg/cubic
meter.
EYE / FACE PROTECTION REQUIREMENTS:
When splashing of the material may occur, chemical goggles and/or a face shield
are recommended.
SKIN PROTECTION REQUIREMENTS:
Where contact is likely, wear chemical resistant gloves.
RESPIRATORY PROTECTION REQUIREMENTS:
Under normal use conditions, with adequate ventilation, no spec ial handling
equipment is required. If mists are produced, local ventilation may be required
to keep exposure below limits.
EXPOSURE GUIDELINES:
No Information Available.