Instruction Manual

Milestone Husky M30/M50
Administrator's Manual
www.milestonesys.com
66
Advanced configuration
Disabled motion detection
Camera's recording
settings
Recordings
Motion-based
events
Non-motion
based events
Sequences
Always
Yes
No
Yes
No
Never
No
No
Yes
No
Built-in Motion
Detection
No
No
Yes
No
Built-in Motion
Detection & Event or
Event only
Yes (depending
on settings)
No
Yes (depending
on settings)
No
About motion detection and PTZ cameras
Motion detection generally works the same way for PTZ (pan-tilt-zoom) cameras as it does for regular
cameras. However, you cannot configure motion detection separately for each of a PTZ camera's
preset positions.
 In order to activate unwanted recordings, notifications and more, the system automatically
disables motion detection while a PTZ camera moves between two preset positions. After a
number of seconds, the transition time, specified as part of the PTZ camera's PTZ patrolling
properties (see "PTZ patrolling" on page 102), the system automatically enables motion
detection again.
Configure camera-specific schedules
If you base your schedule profile—or parts of it—on events within periods of time, remember to select
Start event and Stop event from the lists below the calendar section.
Tip: If you have not yet defined any suitable events, you can quickly do it: use the Configure events
list, located below the other fields.
The fact that a camera transfers video to Milestone Husky product does not necessarily mean that
video from the camera is recorded. Recording is configured separately, see Configure video and
recording (see "About video and recording configuration" on page 64).
For each camera, you can create schedule profiles based on: