Instruction Manual

Milestone Husky M30/M50
Administrator's Manual
www.milestonesys.com
67
Advanced configuration
Online periods
 Periods of time (example: Mondays from 08.30 until 17.45), shown in pink:
 Events within periods of time (example: from Event A occurs until Event B occurs Mondays
from 08.30 until 17.45), shown in yellow:
The two options can be combined , but they cannot overlap in time.
Speedup
 Periods of time (example: Mondays from 08.30 until 17.45), shown in olive green:
E-mail notification
 Periods of time (example: Mondays from 08.30 until 17.45), shown in blue:
PTZ patrolling
 Periods of time (example: Mondays from 08.30 until 17.45), shown in red:
 If use of one patrolling profile is followed immediately by use of another, run your mouse
pointer over the red bar to see which patrolling profile applies when.
SMS notification
 Periods of time (example: Mondays from 08.30 until 17.45), shown in green:
Set up a profile
1. In the Schedule Profiles list, select Add new....
2. In the Add Profile dialog, enter a name for the profile. Names must not contain any of these
special characters: < > & ' " \ / : * ? | [ ]
3. In the top right corner of the dialog, select Set camera to start/stop on time (to base
subsequent settings on periods of time) or Set camera to start/stop on event (to base
subsequent settings on events within periods of time).
Tip: You can combine the two, so you may return to this step in order to toggle between the
two options.
4. In the calendar section, place your mouse pointer at a required start point, then hold down the
left mouse button, drag the mouse pointer and release at the required end point.
o You specify each day separately.