Installation Guide

Installation Instructions for Undermount Handmade and Apron Sinks
4 / 6
Installation (continued)
3
Drilling holes for the clips
□ On the underside of the counter, mark
the location of the twelve holes for the
clips. These holes should be equally
spaced around the perimeter of the
cutout.
□ Using an electric drill with a 11 mm drill
bit, drill each hole so that it is 11 mm in
diameter and 14 mm deep.
□ Insert the plastic caps from each of the
clips into each of the installation holes.
4
Installing the sinks
□ Insert the screws (1) loosely in the holes
that you drilled to the underside of the
counter. Ensure that you use the clips in
the locations that have the narrowest
clearance between the sink and
counter.
□ Place a small bead of silicone sealant
(not included) around the upper lip of
the sink (A).
□ Carefully place the sink (A) into its
location under the counter, with the lip
of the sink being supported by the clips
(AA).
□ Tighten the screws (1) evenly, ensuring
the sink (A) remains in place.
□ Wipe away any excess silicone and, for
best results, allow the bond to rest
undisturbed for 8 hours or overnight.