User's Manual

MWC-434m User Manual
Miliwave
5 / 6
8.0 Module Integration Instructions
List of applicable FCC rules
This module complies with part 15.255 of the FCC rules.
Limitation of the module use case
15.255(a) Operation under the provisions of this section is not permitted for the following
products:
(1) Equipment used on satellites.
(2) Field disturbance sensors, including vehicle radar systems, unless the field disturbance
sensors are employed for fixed operation, or used as short-range devices for interactive
motion sensing. For the purposes of this section, the reference to fixed operation includes
field disturbance sensors installed in fixed equipment, even if the sensor itself moves within
the equipment.
Limited module procedures
Not applicable
Trace antenna designs
Not applicable
RF exposure considerations
This module complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. The module is limited to installation in mobile or fixed applications. At least 20
Cm of separation distance between the transmitting antenna and the user’s body must be
maintained at all times.
The host manual shall include the RF exposure statements.
If RF exposure statements and use conditions are not provided, then the host product
manufacturer is required to take responsibility of the module through a change in FCC ID (new
application).
Antennas
The module itself has antenna. (Broad band array antenna)
Label and compliance information
The module is labeled with its own FCC. If the FCC ID is not visible when the module is
installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. In that case, the final end
product must be labeled in a visible area with the following:
“Contains FCC ID: 2AVCWMWC434M”