User Manual

Resetting the heater

Memory function

The heater remembers all the temperature settings and will automatically return to the

desired temperature after a power failure. If your heater is connected to WiFi it will

automatically reconnect with WiFi (where all temperatures are saved) after a power cut.

Instructions

Turn off the heater´s main switch. Turn the heater back on, within 5 seconds press and

hold .After 20 seconds the display will show "Fr", once you see "Fr" release

and the heater will reset to factory settings.

Control Panel

TIPS! The thermostat can be used as a regular electronic thermostat (i.e. the

heater will maintain a constant temperature 24 hours a day). Please see the section

explaining usage without WiFi connection for further information

ATTENTION! In the event of a power cut, the thermostat will reconnect with WiFi

where all the temperatures are saved.

WARNING! BEFORE THE HEATER IS TURNED ON, IT MUST BE ATTACHED TO A WALL.

IF THE HEATER IS NOT INSTALLED CORRECTLY OR IS INSTALLED ASKEW, THIS MAY

CAUSE THE HEATER TO MALFUNCTION OR IN THE WORST CASE, BE DAMAGED.

1. Display (shows the desired room temperature by default)

2. WiFi indicator

3. Power indicator — Shows whether the heater is using power or not

4. Control button (+) (increase temperature)

5. Control button (–) (reduce temperature)

6. WiFi button

7. Settings button

8. LED lights indicating how much power the heater is using

9. ON/OFF indicator

The heater has an “open window” function that is activated instantly when it registers a

sudden drop in temperature with more than 5 degrees Celsius in 15 minutes. The heater will

automatically stop heating and FO will be visible in the display of the heater.

While in open window mode, it will maintain 5°C (to avoid frost damage).

The heater will automatically start heating again if temperature increase by at least

3 degrees within 15 minutes.

You can switch the heater back to normal mode by pressing the settings button 1 time.

Open window function can be disabled/enabled by pressing and holding the settings

button for 3 seconds. You can also disable/enable open windows function from the app

if conﬁgured to WiFi.

The heater will stay in open window mode for maximum 1 hour, it then will go back

to normal heating mode.