Manual

page 25 of 40 rev 1.4.2 041409 Millennia Media HV-3R
Assigning the HV-3R Outputs to
Recording Interface Inputs in Pro
Tools
In order to have Mic Preamp controls available in Pro
Tools you have to map the outputs of the HV-3 R to
the inputs on your Recording Interface. Make sure
you know which outputs of the HV-3R are going into
which inputs on your Recording Interface before
proceeding.
1. Click the “Setup” pull down menu and choose
“ I / O … ” ( see I/O Setup window above)
2. Click the “Mic Preamps” tab.
3. In the left column “PRE #1” should be displayed,
and in the right column you should see your
Recording Interface and the channels it has
available with little boxes under each one.
4. Click the box for the Input on your Recording
Interface that corresponds to the first output of
the HV-3R.
5. The first output will appear in the box you
clicked while the next seven outputs will appear
in the boxes to the right. You can move the
outputs of the HV-3R around. Be sure that the
chosen inputs in Pro Tools correspond to how
they are connected physically to the Recording
Interface.
It is crucial that all outputs and inputs
correspond correctly or else when you
try to control an HV-3R channel in Pro
Tools it will control the wrong one or
none at all.
If multiple HV-3R units are being used
make sure that none of the channel
outputs of the HV-3Rs share inputs on
your Recording Interface. This will
cause many problems.
It is recommended that you connect
Outputs 1-8 of the first HV-3R to Inputs
1-8 on the Recording Interface and then
Outputs 1-8 on the second HV-3R to
Inputs 9-16 on the Recording Interface
and so on.