User Manual
Table Of Contents
- About This Guide
- Introduction
- Kit Installation
- iB-5209 Network Monitor Operations
- iB-5209 Network Monitor Overview
- Setting Thread Priority
- Configuring a Node’s Operation
- Using Watch function to display current I/O information
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (RT-5209 only)
- Configuring RS-485 Operation (RT-5209 only)
- Labeling i-Bean Endpoint or i-Bean Router
- Creating an Event Log File
- Configure Persistence Attributes
- Configure Serial and ADC Data Formats
- Select Com Port on Host PC
- View Monitor Statistics
- View Contents of Event Log File
- Enable Multiple Capture
- API Functions
- Sample Application
EK-5209-5 Evaluation Kit User’s Guide 2-5
Hardware Installation
i-Bean Gateway status LED operation
Table 2-1 describes how the status LEDs on the i-Bean Gateway behave.
* A device’s LED1 will flash when detecting valid packets (packets destined for device) and may
also flash when detecting invalid packets (packets destined for other devices) or environmental
noise. Only valid packets are processed by the device.
Table 2-1. i-Bean Gateway Status LEDs
Device Status LED1 (red) LED2 (green)
• Power off Off Off
• Power on
• Host PC connected
• iB-5209 Network Monitor not
running
N/A Illuminates; flashing
(0.5 second On/ 0.5 second Off)
• Power on
• Host PC connected
• iB-5209 Network Monitor
running
N/A Illuminates; solid
• Power on
• Network traffic exists*
Illuminates; flashing
(indicating network activity)
Illuminates; solid