User Manual

EK-5209-5 Evaluation Kit User’s Guide 2-9
Hardware Installation
i-Bean Endpoint Setup (iB-5209)
The i-Bean Endpoints, model number iB-5209, are mounted to terminal boards as shown in
Figure 2-4. A terminal board provides easy access to I/O connections and the power switch. The
terminal board also contains a battery holder and battery for supplying power to the i-Bean
Endpoint. The label on top of the i-Bean Endpoint denotes the last three digits of the device ID
assigned to the i-Bean Endpoint.
Figure 2-4. i-Bean Endpoint and terminal board (top and bottom views)
To provide power to the i-Bean Endpoint, a 3 VDC lithium coin cell (CR2032 type) is provided
and already installed in the battery holder on the back of the terminal board.
To activate an i-Beam Endpoint:
• Turn the terminal board's power switch ON (refer to Figure 2-4). Repeat this step for each
i-Bean Endpoint.
Note:
C
Configuring and connecting an i-Bean Endpoint or i-Bean Router to external devices
via their digital or analog I/O connectors is discussed in Chapter 3, “iB-5209
Network Monitor Operations”.
i-Bean Endpoint
Terminal Board
(SL1) Battery Connector
3 VDC Lithium Coin Cell
Lithium Coin Cell Holder
Analog I/O
Terminal Strip
Digital I/O
Terminal Strip
Power Switch
ON/OFF
Device ID