User Manual
Table Of Contents
- About This Guide
- Introduction
- Kit Installation
- iB-5209 Network Monitor Operations
- iB-5209 Network Monitor Overview
- Setting Thread Priority
- Configuring a Node’s Operation
- Using Watch function to display current I/O information
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (RT-5209 only)
- Configuring RS-485 Operation (RT-5209 only)
- Labeling i-Bean Endpoint or i-Bean Router
- Creating an Event Log File
- Configure Persistence Attributes
- Configure Serial and ADC Data Formats
- Select Com Port on Host PC
- View Monitor Statistics
- View Contents of Event Log File
- Enable Multiple Capture
- API Functions
- Sample Application
3-20 EK-5209-5 Evaluation Kit User’s Guide
iB-5209 Network Monitor Operations
Labeling i-Bean Endpoint or i-Bean Router
The following procedure describes the steps required to assign a label to an i-Bean Endpoint or
i-Bean Router (see Figure 3-11):
1. From iB-5209 Network Monitor, select Edit>Labels. The Edit Labels window displays.
2. Enter the Device ID of the desired i-Bean Endpoint or i-Bean Router.
3. Enter the label to be applied to the node(s), then select Set. iB-5209 Network Monitor
displays the label in the Label column of the selected node.
4. Repeat Steps 1–3 for each node, then select X to exit the Edit Label window.
Figure 3-11. Labeling i-Bean Endpoint or i-Bean Router
Select Edit>Labels
1
Enter label information,
3
then select Set
Select X
4
Enter node ID
2
Node label added