User Manual
Table Of Contents
- About This Guide
- Introduction
- Kit Installation
- iB-5209 Network Monitor Operations
- iB-5209 Network Monitor Overview
- Setting Thread Priority
- Configuring a Node’s Operation
- Using Watch function to display current I/O information
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (RT-5209 only)
- Configuring RS-485 Operation (RT-5209 only)
- Labeling i-Bean Endpoint or i-Bean Router
- Creating an Event Log File
- Configure Persistence Attributes
- Configure Serial and ADC Data Formats
- Select Com Port on Host PC
- View Monitor Statistics
- View Contents of Event Log File
- Enable Multiple Capture
- API Functions
- Sample Application
EK-5209-5 Evaluation Kit User’s Guide 3-25
View Monitor Statistics
View Monitor Statistics
The following procedure describes how to view the network statistics recorded by iB-5209
Network Monitor, which provides information on the packets received and transmitted by the
network nodes (see Figure 3-16):
1. From iB-5209 Network Monitor, select View>Monitor Statistics. The Monitor Statistics
window opens, displaying the following information:
– Started Time: Date/time statistics recording session began.
– Current Time: Current date and time.
– Elapsed Time: Total recording time.
– RX Bytes: Total bytes received.
– RX Packets: Total packets received.
– Endpoint Packets: Packets received from i-Bean Endpoints.
– Duplicates: Duplicate packets received.
– Router Packets: Packets received from i-Bean Routers.
– Gateway Packets: Packets received from i-Bean Gateway.
– Malformed: Packets detected that are malformed.
– Bad Length: Packets detected with incorrect length.
– Bad Checksum: Packets detected with incorrect check sum.
– TX Bytes: Total bytes transmitted.
– TX Packets: Total packets transmitted.
2. (optional) Select Clear All to clear the information currently displayed and begin a new
recording session.
Figure 3-16. Viewing monitored statistics
Select View>Monitor Statistics
1
(optional) Select Clear All to clear
display and start new recording session
2