User Manual
Table Of Contents
- About This Guide
- Introduction
- Kit Installation
- iB-5209 Network Monitor Operations
- iB-5209 Network Monitor Overview
- Setting Thread Priority
- Configuring a Node’s Operation
- Using Watch function to display current I/O information
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (RT-5209 only)
- Configuring RS-485 Operation (RT-5209 only)
- Labeling i-Bean Endpoint or i-Bean Router
- Creating an Event Log File
- Configure Persistence Attributes
- Configure Serial and ADC Data Formats
- Select Com Port on Host PC
- View Monitor Statistics
- View Contents of Event Log File
- Enable Multiple Capture
- API Functions
- Sample Application
EK-5209-5 Evaluation Kit User’s Guide B-3
Application Overview
Figure B-2 describes the process flow.
Figure B-2. Process flow
Application Components
In addition to the i-Bean Gateway and iB-5209 Network Monitor software supplied with the
EK-5209-5 Evaluation Kit, the following items are included for the sample application:
• i-Bean Endpoint (removed from one of the kit terminal boards)
• Temperature sensor assembly: This assembly contains a factory installed terminal board
and temperature sensor. The terminal board is also equipped with a factory-installed
battery for providing power to the i-Bean Endpoint. (i-Bean Endpoints
• TempMonitor application software (automatically loaded on host PC when contents of
kit CD are installed)
Note:
Before using the temperature sensor assembly for this sample application, you will
need to install an i-Bean Endpoint (see ’Temperature Sensor Assembly Setup’ on
page B-4)
Temperature Change
Resistance Change
Voltage Change
ADC Reading Change
ADC Reading Change
Temperature Change
Temperature sensor
Closed circuit with power
ADC reading
Wireless network
TempMonitor application