User Manual
Table Of Contents
- RK-5409-5 Reference Kit for 916 MHz MeshScape™ Systems
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (MN-5409 only)
- Configuring RS-485 Operation (MN-5409 only)
- Using Watch Function to Display Configuration Information
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Sample Application
- B: Performing Firmware Upgrades and Configuring Device IDs
- Glossary
- Index
2-10 Millennial Net
Installing the MeshScape System
7. Turn the Power Switch ON. The mesh node is ready to operate as a router device (see
note below). For information on the behavior of the status LEDs, see
Table 2-3 on page
2-8.
8. Replace the cover and secure in place with the four philips head screws.
Figure 2-8.Installing mesh node battery pack
Accessing I/O connections
Figure 2-9 on page 2-11 provides a mapping of the various I/O connections available on the
mesh node. To run a cable to an I/O connector, a punch-out is provided on the bottom of the
case (to the right of the battery pack shown in
Figure 2-8 above).
To access the mesh node’s I/O connectors:
Note:
C
For information on accessing and using the mesh node internal I/O connections for
interfacing with an external device see
’Accessing I/O connections’ on page 2-10.
Cover and Cover Screws (4)
AC Adapter Cable
(remove)
Power Switch
Battery Pack with 2
Mounting Screws
(install)
Connector SL1
Product Label with:
- Model Number
- GroupID
- Device ID