User Manual
Table Of Contents
- RK-5409-5 Reference Kit for 916 MHz MeshScape™ Systems
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (MN-5409 only)
- Configuring RS-485 Operation (MN-5409 only)
- Using Watch Function to Display Configuration Information
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Sample Application
- B: Performing Firmware Upgrades and Configuring Device IDs
- Glossary
- Index
3-20 Millennial Net
Running MeshScape Network Monitor
Configuring Persistence Attributes
The following procedure describes how to configure the persistence setting of the network’s
end nodes and mesh nodes (see
Figure 3-23):
1. From MeshScape Network Monitor, click on the desired device from the list of discovered
sensor nodes.
2. From MeshScape Network Monitor, select Edit>Persistence. The Edit Persistence
window is opened.
3. Configure the following persistence attributes:
– Show previous devices at startup: If selected, all online nodes will be displayed
when MeshScape Network Monitor is started.
– Show previous offline devices at startup: If selected, all online and offline nodes
will be displayed when MeshScape Network Monitor is started.
– Delete: Select the delete button to stop displaying the selected Offline node.
– Delete all: Select this delete button to stop displaying any node with a status of
Offline.
4. Click Prev or Next to apply persistence attributes to other discovered sensor nodes.
5. Select X to exit the Edit Persistence window.
Figure 3-23. Configuring node persistence attributes
Select Edit>Persistence
2
Select X
5
Configure persistence attributes
3
Click Device
1
Select Prev or Next
4