User Manual
Table Of Contents
- RK-5409-5 Reference Kit for 916 MHz MeshScape™ Systems
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (MN-5409 only)
- Configuring RS-485 Operation (MN-5409 only)
- Using Watch Function to Display Configuration Information
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Sample Application
- B: Performing Firmware Upgrades and Configuring Device IDs
- Glossary
- Index
3-22 Millennial Net
Running MeshScape Network Monitor
Configuring Serial and ADC Data Formats
The following procedure describes how to configure the format of displayed serial and ADC
information (see
Figure 3-25):
1. From MeshScape Network Monitor, select Edit>Data format. The Edit Data Format
window is opened.
2. Configure the following network attributes:
– Serial data format: Select the desired format for displaying serial data
(ASCII/Hex/Decimal).
– ADC data format: Select the desired format for displaying ADC data
(Voltage/Raw
Data).
3. Select OK to save the settings and exit the Edit Network window.
Figure 3-25. Configuring serial and ADC data formats
Select Edit>Data Format
1
Select OK
3
Configure data format attributes
2