Product Info
ENG
1. IMPORTANT INFORMATION
Before using this device, please read the
following safety notes and operating instructions
completely, and pay careful attention to them.
Please store this user manual with the device, so
that you can refer to it later if needed. If you later
give this device to another user, please also give
them this manual.
This device is intended for private use in dry
indoor rooms.
1.1. Safety instructions
• Please note that this product is not a child’s
toy within the meaning of Directive 2009/48/
EC. If you let your children use the device,
ensure you instruct them accordingly
and ensure that the device is used only as
intended.
• Keep the packaging bags and lm away from
babies and small children, as there is a danger
of suffocation!
• In order to avoid damage, do not expose the
device to heat, eg from radiators or from direct
sunlight, and do not expose it to any kind of
moisture.
• In order to avoid malfunctions, do not operate
the device on or near devices that create
magnetic elds or electromagnetic radiation,
such as for example televisions, loudspeakers,
mobile and cordless telephones, WiFi devices
etc.
• To charge the eONE’s built-in battery, use a
5V USB mains adaptor that has at least 0.6A
power.
• Regularly inspect the device for damage, and
do not use it if damaged.
1.2. Notes on using the mains adaptor
• The power socket should be located close to
the device and should be easily accessible.
• The device should not be connected to more
power sources than recommended.
• The electrical contacts must not be short-
circuited.
• Always disconnect the adaptor from the mains
before cleaning the device.
• Regularly check the product and the mains
adaptor for damage, and do not use either of
them if they are damaged. Never open them
up.
• Please follow the safety instructions on the
mains adaptor.
2. CALIBRATING THE BOARD
From time to time, the eONE board must be
recalibrated. The board’s sensors can for example
react to temperature changes or changes in
humidity levels.
It is easy to recognise if the board should be
calibrated. For example:
• Moves are regularly not detected
• Or squares sporadically icker, even though no
piece has been placed on them
• Or the 3 front buttons activate themselves, or
lose their function.
To calibrate the board, proceed as follows:
1. Completely clear the board and clean the
surface. Ensure there are no objects (including
ngers) on the playing surface.
2. The device must be switched on.
3. Press and hold the ON/OFF button for around
10 seconds, until all the squares’ LEDs light up.
Then release the button.
4. A blinking pattern across the entire
chessboard shows that calibration is in
progress.
5. Once the LEDs ash in starting position,
calibration is complete and the eONE is ready
for use again.
3. TECHNICAL DATA
• Item No: M841
• Frequency: 2402-2480MHz
• Range: approx 8m
• Charging time: 4 hours
4. EC CERTIFICATE OF
CONFORMITY
Millennium 2000 GmbH hereby declares
that eONE M841 conforms to the relevant
EC directives (in particular those mentioned
below), and that the series was manufactured
accordingly:
• (RED) Radio Equipment Directive (R&TTE)
2014/53/EU
• (WEEE) Waste Electrical and Electronic
Equipment Directive 2012/19/EU
• (RoHS) Restriction of Hazardous Substances
Directive 2011/65/EC
The certicate of conformity may be viewed at:
http://millennium2000.de/doc/M841_doc.pdf
MILL WI eOne 2021 f01.indd 5MILL WI eOne 2021 f01.indd 5 07.12.21 16:4907.12.21 16:49