Owner`s manual

. A complete Parts List is available at www.MillerWelds.com

OM-2248 Page 12

5-2. Cutting Speed

The cutting speed curve shows the

recommended maximum cutting

speed capabilities of the power

source and torch for mild steel of

various thickness.

The best cut quality is achieved by

cutting near the chart line. Cutting

below the line (too slow) will result

in excess dross. Cutting above the

line (too fast) will cause blowback

and lack of penetration.

. Recommended production cutting speed vs. material thickness is approximately

10 ipm at 1/8 in (3.2 mm) mild steel thickness at max setting.

5-3. Trigger Safety Lock

Trigger Locked Trigger Unlocked

1 Trigger

801 545-A