Owner`s manual

OM-1324 Page 12
SECTION 3 – INSTALLATION
3-1. Installing Welding Gun
Ref. 802 982 / Ref. 801 987
1 Drive Assembly
2 Gun Securing Knob
3 Gun End
Loosen knob. Insert gun end
through opening until it bottoms
against drive assembly. Tighten
knob.
4 Gun Trigger Plug
Insert into receptacle, and tighten
threaded collar.
Close door.
4
2
3
1
3-2. Installing Work Clamp
1 Nut
2 Work Cable From Unit
3 Work Clamp
4 Screw
5 Work Clamp Tabs
Bend tabs around work cable.
802 456
1
2
3
4
5
Tools Needed:
3/8, 7/16 in
3-3. Work Cable Routing Inside Unit
Ref. 802 982
1 Work Cable
2 Output Terminal Block
Insert work cable through opening
in front panel and route along back
of front panel to output terminal
block.
Close door.
2
1