Owner`s manual

SAFETY

See “Operating the Curbilder,” page 30 for location of machine controls.

This symbol applies to all items in the Safety section unless otherwise noted.

This CAUTION symbol indicates a possibility of Personal Injury or Equipment

Damage if the Instructions in this manual and on the decals attached to the machine

are not followed.

This DANGER symbol, when it appears, indicates a strong possibility of Severe

Personal Injury or Death if the Instructions in this manual and on the decals attached

to the machine are not followed.

These safety and operating instructions for Miller Spreader curbing equipment are for your

protection. Careless regard of these instructions and other safe construction practices could

result in accidents and injury. Read and Understand this manual and ALL Decals located on

this machine BEFORE putting this machine into service.

A. General Safety

 Replace damaged or worn decals.

 Replace damaged or worn decals only with original equipment decals. Do not

modify decals in any way.

 Know what safety equipment is required to operate and maintain this machine.

Safety equipment must include but not limited to Safety Glasses, Reflector type

Vests, Gloves, Ear Protection and Steel Toed Work Boots.

 Never operate or perform any maintenance on this machine while under the

influence of Drugs and/or Alcohol.

A qualified service mechanic using only MILLER SPREADER replacement parts

or their approved equal must make all repairs to this machine. Any deviation from

the original MILLER SPREADER supplied machine in the operation, repair,

and/or modifications of the machine without the express written consent of the

MILLER SPREADER COMPANY, voids all machine warranties and any liability

for injuries and/or damage to person or property.

B. Before putting this equipment into operation inspect the equipment daily.

 Inspect this equipment on a hard and level surface.

1. Shut engine off. “LOCK-OUT, TAG-OUT Equipment BEFORE serving.

2. Push in any one (1) Emergency Stop Switch and remove Spark Plug Wire(s) to

prevent accidental starts.

3. Block wheels in both directions to prevent machine movement. Lower machine

using the three (3) Wheel Height Adjustment Cranks until Auger Housing

Assembly engages the ground and the Curb Machine is Immobile.

4. Inspect belt tension/chain tension. Adjust if required. See “Machine Adjustment

Section”.