Owner`s manual

5. Inspect auger for wear. Repair or replace if required. See “Machine Cleaning and

Maintenance Section”.

6. Inspect tires, wheels and tire pressure on pneumatic tire models. Air pressure

should be 30 PSI.

7. Inspect all operating controls: Engine Speed Control Linkage, Steering Handle,

Service Brake and Wheel Height Adjustment three (3) places.

8. Inspect Safety Torque Arm Assembly for proper operation, cleanliness, and

adjustment. See “Machine Adjustment Section”.

9. Inspect engine oil level. Follow all maintenance as outlined in the “Machine

Cleaning and Maintenance Section”.

10. Before adding fuel:

 A hot and/or running engine can ignite spilled gasoline.

 Shut engine off.

 Let engine cool off a minimum of 5 minutes

 Extinguish smoking materials

 Use funnel

 Do not overfill

 Replace fuel cap after adding fuel.

 Exercise extreme caution when refueling.

 After making Inspections and Adjustments 1-10, REPLACE ALL MACHINE

GUARDS. Start engine. Verify that centrifugal clutch operates correctly. At idle

speed the clutch fully Disengages auger drive and the auger stops turning. When

engine speed is increased to full speed, the clutch engages and auger turns freely.

Do not operate the Curbilder unless Centrifugal Clutch operates correctly.

 Make any necessary repairs or adjustments before putting this equipment into

operation. All repairs must be made by qualified service personnel using only

MILLER SPREADER replacement parts or their approved equal. Any deviation

from the original MILLER SPREADER supplied machine in the operation, repair

and/or modifications of the machine without the express written consent of the

MILLER SPREADER COMPANY voids all machine warranties and any liability for

injuries and/or damage to person or property. ALL GUARDS MUST BE IN

PLACE AND FUNCTIONAL. Refer to the “Machine Cleaning and Maintenance”

and Machine Adjustments Sections” of this manual.

C. Familiarize yourself with the work site and job conditions PRIOR to using the

Curbilder.

This equipment must only be operated by trained personnel who fully understand

its safe operation. Each operator must be able to identify any unsafe worksite

conditions and report these conditions to his supervisor for immediate

correction.

Do not start or operate this equipment in an unventilated area.

 A GASOLINE ENGINE DISCHARGES CARBON MONOXIDE GAS WHICH

CAUSES INJURY OR DEATH IF INHALED. ENGINE EXHAUST AND SOME OF

ITS CONSTITUENT

ES ARE KNOWN TO CAUSE CANCER, BIRTH DEFECTS

AND OTHER REPRODUCTIVE HARM. DO NOT OPERATE THIS MACHINE IN A

BUILDING OR OTHER AREA WHERE THERE IS NOT ADEQUATE

VENTILATION FOR THE OPERATOR. WHERE THERE IS ANY POSSIBILITY