Owner`s manual

D. Operation of this equipment

Use caution when operating near other people and obstructions. Always look to

the rear before backing up and back up slowly.

Never operate Curbilder with safety torque arm out of adjustment or serious

injury may result.

Never feed auger with a tool that could get caught in a turning auger and strike

someone.

 Know the two(2) ways a Curbilder Auger can be Stopped:

1) IN AN EMERGENCY:

Push IN any one (1) of the Emergency Stop Switch RED Buttons on the

Curbilder. On Models MC-550, MC-650 and MC-655 there are two (2)

Emergency Stop Switches located on BOTH ends of the Belt Guard (Part

#45010-17). On Models MC-850 and MC-900 there are two (2) additional

Emergency Stop Switches located at the left and right rear corners of the

machine frame. These Emergency Stop Switches have two (2)

MAINTAINED POSITIONS: Pulled OUT Position, Engine/Auger will

operate; Pushed IN Position, Engine/Auger will not run. Note: On all

machines manufactured prior to July 2007 there is one (1) Emergency

Stop Switch located on the Belt Guard and/or the engine. The operation

of this switch requires that the switch be pushed in and HELD IN to stop

Engine/Auger.

2) In Normal Machine On-Off Operation:

Use the Engine Speed Control (Throttle) to Decrease engine speed to the

slowest Idle Speed (750 RPM) to DISENGAGE the Centrifugal Clutch.

Know how to operate the Engine Throttle on your machine BEFORE

putting the machine into service:

A) MC-550, MC-650, MC-655, built after November 2007 see page 31 of

this manual and Parts Drawing #45130-01 in the complete Parts

Manual, Part #35001-01.

B) MC-850, MC-900 built after February 2007 see page 31 of this manual

and Parts Drawing #45028-01 in the complete Parts Manual, Part

#35001-01.

C) MC-550, MC-650, MC-655 built between February 2006 to November

2007 Parts Drawing #45142-08.

D) MC-850, MC-900 built between February 2006 and February 2007

Parts Drawing #45142-08.

E) On all models of Curbilders built prior to February 2006 the Engine

Speed Control is accomplished by using the throttle located on the

engine. Refer to your engine manual for operation.

 This vehicle is not intended for the transportation of any personnel. NO RIDERS!

 Do not operate equipment with oily dirty gloves and/or controls.

 Do not operate recklessly. Careless operation causes accidents and injury.