Owner`s manual

C. To lift Curbilder

 To lift the Curbilder use a crane or other mechanical hoist rated at a 1,500#

Working Load and:

 Position the chains or straps as follows:

a) One (1) at the front corner formed by the motor mount and the

Curbilder frame.

b) Two (2) at rear corners formed by the auger housing and the

Curbilder frame.

 Position each chain or strap in a “U” shape around the Curbilder

frame.

 Adjust chains or straps so that when the Curbilder is lifted it is level in

both length and width.

Use OSHA approved lifting/tie down chains and straps that are

designed to have a minimum working load limit of 2500# per chain or

strap. Lift or tie down Curbilder only when hopper is empty. Only

transport Curbilder with engine off. Turn fuel switch to off position to

prevent fuel from entering crankcase.