Owner`s manual

20
Preparing for the Job
Choosing the Curb Form
Miller Spreader has manufactured over 1600 different Curb Forms. Any of these Curb Forms
are available or you may request a Curb Form to your specific dimensions.
To Order a Curb Form:
A. If you have an existing Curb Form locate the stamped number (one (1) to five (5)
digits/letter) on the outside face of the curb form mounting flange. Submit this
number to your local Miller Dealer. Be sure to note any special features your Curb
Form can have, for example, does it operate over dowel pins, will it extrude 3/8”
(#3) reinforcing rod rebar through the center of the auger shaft, etc.
B. If you have a drawing with dimensions or a full size tracing of the exact shape of
the curb form you want to purchase, submit this information to the Miller Spreader
Company. Be sure to note any special features your Curb Form can have, for
example, does it operate over dowel pins, will it extrude 3/8” (#3) reinforcing rod
rebar through the center of the auger shaft, etc. The Miller Spreader Customer
Service Department will try to match your Curb Form information with our listing of
previously manufactured forms. If your Information matches a form made
previously, the number and drawing of this form will be sent to you. If the form has
never been made a new Curb Form Design (CFD) Number will be assigned.
C. For Curb Forms in which the shape is non-symmetrical (Drawing a vertical center
line down the center of a Curb Shape, the left and right halves of the Curb Form
Shape are not the same) a left or right hand Curb Form must be determined.
To determine Curb Form Hand for non-symmetrical Curb Forms:
i. Imagine a Curbilder equipped with the desired curb form to be in operation
moving AWAY from an observer at the rear of the machine (where the curb
comes out). See drawing below.