Owner`s manual

For Curbilder Models MC-850 and MC-900:

1) Place the Curbilder on a LEVEL concrete or asphalt surface. Block the

Wheels in both directions. Leave the Front Wheels on the Ground.

2) With the machine secure on a level, hard surface and the two (2) bolts

holding the Front Wheel Support loosened, push the Front Wheel Support

in the direction desired using the Pry Bar supplied with the machine.

Place the flat end of the pry bar in any slot in the Front Wheel Support

and engage another slot in the angled bracket in the front of the frame of

the machine. Push the Front Wheel Support with the pry Bar in the

direction desired. Repeat this action until the wheel closest to the curb

form is approximately two (2”) inches from the inside edge of the Curb

Form.

DO NOT STRIKE THE FRONT WHEEL SUPPORT WITH A HAMMER.

2) Tighten the Two (2) bolts holding the Front Wheel Support.

3) Leave the Pointer Assembly loose until the Curbilder is in position

to place curbing. Then tighten in position as required.