Owner`s manual

40
12) Reattach the Chain Guard.
13) Assemble the Deflector in the correct position in the bottom of the Hopper for
the Auger size selected.
14) Install the Hooper in the machine sliding the bottom opening of the hopper into
the top opening of the Auger Housing Assembly. Secure the hopper to the
frame by swinging the two (2) Hooper Bolts into the slots in the Hopper
Flanges. Tighten both Wing Nuts on the Hopper Bolts.
15) Attach the Curb Form to the flanged end of the Compaction Tube using three
(3) ½”-13NC Bolts, Lock Washers and Nuts. Then turn the “T” bolt over the
end of the Curb Form CLOCKWISE until the end of the bolt makes firm
contact with the end of the curb form. DO NOT OVERTIGHTEN THIS “T”
BOLT. See page 8, item #5 for drawing.