Owner`s manual

Curbilder Cleaning

CLEAN THE MACHINE EVERYDAY AS OUTLINED. FAILURE TO

CLEAN THE MACHINE EVERYDAY WILL RESULT IN THE AUGER

SEIZING TO THE SHAFT, OTHER DAMAGED PARTS AND AN UNSAFE

MACHINE.

BEFORE CLEANING CURBILDER:

1) SHUT ENGINE OFF.

2) PUSH IN ANY ONE (1) EMERGENCY STOP SWITCH AND REMOVE

SPARK PLUG WIRE(S) TO PREVENT ACCENDENTIAL STARTS.

3) PLACE MACHINE ON A LEVEL CONCRETE OR ASPHALT

SURFACE. BLOCK WHEELS IN BOTH DIRECTIONS AND LOWER

THE CURBILDER USING THREE (3) WHEEL HEIGHT ADJUSTING

SCREWS UNTIL THE AUGER HOUSING MAKES CONTACT WITH

THE GROUND AND THE CURBILDER IS IMMOBILE.

A) To clean the Curbilder after using Asphalt, remove the curb form, compaction tube, and

extrusion auger. Wash and spray parts with No. 2 fuel oil or kerosene. Spray inside of

hopper with No. 2 fuel oil or kerosene. Scrape off all asphalt, which adheres to any

operational surfaces. Inspect auger for wear, reverse or rebuild as required. After cleaning,

grease auger shaft before placing the auger back onto shaft.

B) To clean the Curbilder after use with Concrete, remove the curb form, compaction tube,

and extrusion auger. All parts should be cleaned with water and all deposits scraped from

Curbilder. The inside of the hopper and the auger housing should be thoroughly cleaned

with water, and the auger shaft should be greased, before placing the auger back onto shaft.

For long term storage spray all wear parts with a light protective coating of No. 2 fuel oil.

Curbilder Maintenance

Perform all Maintenance items per the schedule below. A Clean, Properly

Lubricated and Adjusted machine is a SAFE MACHINE. Failure to perform

Machine Maintenance as outlined can cause Injury or Death. Further,

failure to perform Maintenance as outlined will cause damaged parts and

unsatisfactory machine performance.

BEFORE MAINTAINING CURBILDER: