Owner`s manual

New Machine Assembly:

1) Remove Curbilder from Shipping Skid.

2) Loosen the two (2) Hopper Retention Bolts/ Wing nut assemblies. Unlatch the two (2) rubber

hood latches on the Belt Guard which holds the Engine Cover in Place. Fold the Engine

Cover into the hopper. With two (2) people, lift the hopper and engine cover off of the

Curbilder frame and set these parts on the ground. Remove the Steering/Brake Handle that

is shipped on the top of the Curbilder frame.

3) On Electric Start Models:

A) On ALL Electric Start Models the Ignition Keys for the Engine are wire tied to the Ignition

Switch on the Right side of the Engine.

B) On Models MC-650, MC-655:

Remove the two (2) wing nuts on the top of the Black Battery Cover on the Battery Box in

the middle of the Curbilder frame. Then remove the Battery Cover. Connect the Black

Ground to the Left Front Bolt Assembly holding the Battery Box to the Curbilder frame.

Be sure to replace BOTH Star Lock Washers as shown to obtain a good Ground.

Replace Battery Cover. Replace Hopper and Engine Cover.