Owner`s manual
9
8) Reverse the Position of the Rear Wheel Assembly on the Frame of the Curbilder. The Rear
Wheel Assembly is shipped with the Vertical Square Tube placed facing the Front of the
Curbilder. This position prevents shipping damage. To place the Vertical Tube in the correct
position for machine operation:
A) Turn the Rear Wheel Assembly Crank Clockwise until the Rear Wheel Assembly is off
of the ground.
B) Remove the one (1) vertical Retention Bolt holding the Rear Wheel Assembly Clamp
to the horizontal square tube at the rear of the machine.
C) Pull the Rear Wheel Assembly and Bracket off of the square tube of the frame.
D) Reinstall the Rear Wheel Assembly and Bracket to the rear of the Frame of the
Curbilder sliding the Bracket over the Square Tube with the Vertical Rear Wheel
Assembly facing to the REAR of the Curbilder.
E) Locate the outside edge of the Rear Wheel Assembly nearest the Curb Form two (2”)
from the edge of the Curb Form.
F) Replace the vertical Retention Bolt in the Bracket and tighten.