Owner`s manual

OM-263 706 Page 11

4-5. Stick DCEP (Direct Current Electrode Positive) Connections

! Turn off power before mak-

ing connections.

1 Negative (−) Weld Output

Terminal

Connect work lead to negative weld

output terminal.

2 Positive (+) Weld Output

Terminal

Connect electrode holder to posi-

tive weld output terminal.

4-6. Electrical Service Guide

. Actual input voltage cannot exceed -10% of minimum, or +10% of maximum input voltages indicated in table.

Failure to follow these electrical service guide recommendations could create an electric shock or fire hazard. These recommenda-

tions are for a dedicated circuit sized for the rated output and duty cycle of the welding power source.

In dedicated circuit installations, the National Electrical Code (NEC) allows the receptacle or conductor rating to be less than the rating

of the circuit protection device. All components of the circuit must be physically compatible. See NEC articles 210.21, 630.11, and

630.12.

Input Voltage (V)

Three-Phase, 40% Duty Cycle

380 − 440 +/− 10%

Input Amperes (A) At Rated Output 16

Max Recommended Standard Fuse Rating In Amperes

Time Delay Fuses

Normal Operating Fuses

Min Input Conductor Size In mm

(AWG)

2.5 (14)

Max Recommended Input Conductor Length In Meters (Feet) 45 (149)

Min Grounding Conductor Size In mm

(

AWG)

2.5 (14)

Reference: 2011 National Electrical Code (NEC) (including article 630)

1 If a circuit breaker is used in place of a fuse, choose a circuit breaker with time-current curves comparable to the recommended fuse.

2 “Time-Delay” fuses are UL class “RK5” . See UL 248.

3 “Normal Operating” (general purpose - no intentional delay) fuses are UL class “K5” (up to and including 60 amps), and UL class “H” ( 65 amps and

above).

4 Conductor data in this section specifies conductor size (excluding flexible cord or cable) between the panelboard and the equipment per NEC Table

310.15(B)(16). If a flexible cord or cable is used, minimum conductor size may increase. See NEC Table 400.5(A) for flexible cord and cable

requirements.