System information

SECTION TWO - FRONT PANEL OPERATION

F2 (View): Allows viewing of the entire program and lets the operator position to any of the

events in the program. A window similar to the following will be displayed.

F7 ( ↑ ), F8 ( ↓ ), F9 (PgUp), and F10 (PgDn) can be used to move to the desired event. Then

press ESC or Enter to display that event.

F1 (Begin): Marks the block beginning

F2 (End): Marks the block end

F3: Deletes the block of events

F4 Copies the block of events to the cursor position

F5 Moves the block of events to the cursor position

Note: You cannot move, delete, or copy the program setup screen or the end of program events.

F3 (Event) Allows entry of an event number for which to search. If the event number is not

found, the end-of-program screen will be displayed.

F4 (T##) Allows entry to search for a tool number. If tool number is not found the event

displayed will not change.

F6 (Ins) INS is used to insert events in a program. The new event(s) will be inserted before

the event that is currently displayed. Inserting will continue until the F10 (Exit)

soft key is pressed.

F7 (Del) Will delete the event currently being displayed.