System information

SECTION TWO - FRONT PANEL OPERATION
F2 (New) Main-Prog-Conv-New
Pressing the F2 (New) key will allow entry of the number for a new conversational program.
After the number has been entered, the control will check the conversational programs currently
in the parts directory to see if a program by that number already exists. If it does, two warnings
will be displayed and the operator will be allowed to okay the erasing of the conversational
program and its associated text program prior to entering the conversational system. Remember,
conversational programs are stored in both formats.
F3 (Old) Main-Prog-Conv-Old
The F3 (Old) key will allow entry of the number of an existing conversational program. After the
number has been entered, the control will check the conversational programs currently in the
parts directory to see if a program by that number exists. If it does, the edit window will appear
displaying the program setup screen. If not, an error stating that the program was not found will
appear and, after pressing the ESC (Exit) key, another number may be entered.
F4 (Any) Main-Prog-Conv-Any
The F4 (Any) key will allow entry of any file. Specify the drive, path, file name, and extension.
If the name is of the correct format for a conversational program, you will enter the conversation
program mode. If not, you will enter the text programming mode.
Main-Prog-Conv
The menu keys are used to move throughout the conversational system and reach the desired
input screen. The menu key sequence is listed on the Conversational System Flowchart in
Section 6.
- Soft key configuration 3: Programming Keys
Keys displayed in the first level menu:
89