System information

SECTION TWO - FRONT PANEL OPERATION
Verify is used to verify the active program. Upon pressing the F9 (Verf) key, the following
screen appears.
After the above screen appears, push F1 (Start) and the following screen will appear.
The F1 (First) key is automatically selected when entering this screen from the Verf screen.
Therefore, if it is desired to verify the active program from the beginning, you need only to press
the Cycle Start button. If F2 (Block) is pressed, the control will request that the desired block or
sequence number be typed in followed by enter. If Cycle Start is pressed, the active program
will start verifying from the selected block number. If F3 (Tool) is pressed, the control will
request a tool number. After typing the tool number followed by depressing Enter, the
92