System information

SECTION TWO - FRONT PANEL OPERATION

F3 (Graph) Main-Verf-Displ-Graph

If the F3 (Graph) key is activated, the control switches from displaying text to a graphic display

of the active part program. The following screen will appear.

The graphics on this control are full 3D and will be displayed in the graphics area as long as the

control remains in the F3 (Graph) mode. When other displays are requested, windows will

appear in the graphics area showing the requested data. When these functions are concluded, the

windows will disappear and the graphic display will be reinstated. The scale at the top of the

screen is to be used as a reference for the part size. As the screen scale is changed, the

graduations on the ruler will change accordingly. The ruler graduations are in machine units, but

on an English system. The largest graduations equal approximately one inch.

Note: The graphics are cleared from the display at the beginning of running or verifying a

program.

The graphics functions used in the verify mode are the same functions used in the run mode. For

a full explanation of these functions, see page 24, Section 2 on runtime graphics.

F4 (Diag) Main-Verf-Disp-Diag

See page 28, Section 2.