System information

TABLE OF CONTENTS
Work coordinate systems (G54 - G59)(G5#0…G5#9)........................................................... 257
Local coordinate system (G52)............................................................................................... 257
Single direction or one shot rapid positioning (G60).............................................................. 259
Exact stop mode (modal) (G61).............................................................................................. 259
Tapping mode (modal) (G63) ................................................................................................. 259
Cutting mode (modal) (G64) .................................................................................................. 259
Calling a program (G65 P)...................................................................................................... 259
Coordinate system rotation (G68) Cancel Rotation (G69) ..................................................... 260
3D Rotation (G0, G1, G2, G3, G68 AND G69) ..................................................................... 262
Part Scaled then Rotated ......................................................................................................... 263
Part Rotated then Scaled ......................................................................................................... 264
Cancel mirror image (G70)..................................................................................................... 265
Set mirror image (G71)........................................................................................................... 265
Canned cycles ......................................................................................................................... 266
Bolt hole routine (G72)........................................................................................................... 272
High speed peck drilling cycle (G73) ..................................................................................... 275
Left hand soft tapping cycle (G74) ......................................................................................... 276
Counter Bore (G75) ................................................................................................................ 277
Fine bore cycle (G76) ............................................................................................................. 278
Custom drill cycle (G77) ........................................................................................................ 279
Drilling cycle, manual bore (G78).......................................................................................... 280
Canned cycle cancel (G80) ..................................................................................................... 280
Drilling cycle (G81)................................................................................................................ 281
Drill/Dwell cycle (G82) .......................................................................................................... 281
Peck drilling cycle (G83)........................................................................................................ 282
Right-hand soft tapping cycle (G84)....................................................................................... 283
Boring cycle (G85) ................................................................................................................. 284
Fast bore cycle (G86).............................................................................................................. 285
Back Boring cycle (G87) ........................................................................................................ 286
Hard tap cycle (G88)............................................................................................................... 288
Bore/Dwell cycle (G89).......................................................................................................... 289
Absolute/Incremental Mode.................................................................................................... 292
Absolute mode (modal) (G90)................................................................................................ 292
Incremental mode (modal) (G91) ........................................................................................... 293
Floating zero (G92)................................................................................................................. 294
Inverse Time Feed Mode (G93).............................................................................................. 295
Feed Per Minute (G94) ........................................................................................................... 296
Feed Per Revolution (G95) ..................................................................................................... 297
Return to initial level or to R level (G98/G99)....................................................................... 297
G271 (Pocket Clear) ............................................................................................................... 297
Store Restore parameters (G990/G991).................................................................................. 300
Read byte parameter (G995)................................................................................................... 301
Write byte parameter (G996) .................................................................................................. 301
Force Error (G997) ................................................................................................................. 302
Beep (G998)............................................................................................................................ 302
Custom G codes ...................................................................................................................... 302
xi