System information

SECTION TWO - FRONT PANEL OPERATION
F8 (Dry) Main-Verf-Dry
F8 (Dry) run in the verify mode will run the program as fast as possible. For feedrate override
positions 100% and greater – verify speeds are progressively slower for overrides 0-90%.
F9 (Halt) Main-Verf-Halt
F9 (Resum) Main-Verf-Resum
Once a program has been F9 (Halt)ed, the resume feature of the control becomes active. The F9
(Resum) key will now be displayed on the verify screen. A program can be resumed as long as
the resume is active. If the resume function is selected, the active program will be resumed at the
halted point.
The F3, F4, F5, and F8 keys on the verify screen set the mode of operation in which a program
will verify. When these keys are in a highlighted state the functions will be active in any
currently verifying program or program to be verified.
Note: You can switch to run from verifying. This is convenient for long DNC programs
as it picks up on all feeds/speeds/tool offsets/cutter comp/etc. To switch to run
from verifying, you must be in block mode waiting for cycle start. Press the F9
(Halt). The F10 key will no show F10 (Run). When the F10 (Run) is pressed, the
control will be as if a halt resume was done while running a program. Be sure to
take the control out of block and/or dry run if you are in it. Do not try this in the
middle of automatic tool changes or other I/O related routines.
F10 (Util) Main-Util
Keys and options displayed when F10 (Util) is pressed:
96