System information

SECTION TWO - FRONT PANEL OPERATION
F1 (Edit) allows you to modify the tool number in each pocket.
F3 (Dflt) loads the default tool numbers (tool 1 in pocket 1, tool 2 in pocket 2, etc). F7 also
zeroes the tool number in the spindle.
F6 (DNC) Main-Util-DNC
The F6 (DNC) mode is used for running large programs. These programs are not loaded into the
control's memory, therefore they cannot have GO-TO's, WHILE-WEND loops, GO-SUB's, or
CALLS.
Note: CALLS are allowed in fast DNC fast.
GO-TO’s are allowed in run DNC and Verf DNC if the “resolve DNC” parameter is set
to Yes.
When F6 (DNC) is pressed, the following DNC modes appear.
103