System information

SECTION TWO - FRONT PANEL OPERATION
F3 (Fast) Main-Util-DNC-Fast
After pressing F3 (Fast), the following screen will appear.
F1 (RS232)
Depressing F1 (RS232) will wait for data from the Com port, then request a cycle start to begin
the program.
F2 (File)
F2 (File) selects a program from a menu of the programs in the control.
F3 (Disk)
F3 (Disk) selects a program from a menu of the programs on the floppy disk or from local area
network.
F4 (Any)
F4 (Any) allows you to type in the name of any drive, path, file, and extension.
F5 (Old)
F5 (Old) allows you to type in the number of the file you want to run.
F6 (Ram
4
)
F6 (Ram
4
) is used if a program has been loaded to the RAM drive (via RS-232 or floppy disk).
F6 (Ram
4
) will select that program.
After selecting the INPUT mode, the control will request a cycle start to begin the program. All
of the above input modes – except RS-232 – will allow the program to start at locations other
than the beginning. The other options are as follows.
104