System information

SECTION TWO - FRONT PANEL OPERATION
F1 (First)
F1 (First) starts from the beginning.
F2 (Block)
F2 (Block) starts from a sequence number.
F3 (Tool)
F3 (Tool) starts from a tool number.
F4 (Cont)
F4 (Cont) allows starting from a location where DNC was aborted earlier. When a file is aborted
the file position is saved. No checking is performed if the operator has switched file numbers or
modified the DNC file. F4 (Cont) will continue from the file position that was aborted on any
file.
F9 (Skip)
F9 (Skip) will ask for a skip count. If the skip count is non-zero, a cycle start will be requested
for skipping (or ignoring) that number of blocks, and then a second cycle start will run from the
next block.
F10 (Mirr)
F10 (Mirr) allows mirroring around X0 and Y0 in DNC-FAST.
F3 (Fast)
When F3 (Fast) is running, the following display appears.
When the program ends or ESC (Abort) is pressed, the display will show the total DNC time,
total distance, average feedrate, average block time, and average blocks/seconds.
105