System information

SECTION TWO - FRONT PANEL OPERATION
This mode should be used for large programs where a fast block rate is required, for example
when making short moves at fast feedrates. No trig help, cutter comp, rotating, scaling, or other
non-standard commands, can be done in this mode. Valid data for the fast mode are:
X, Y, Z, A, B, I, J, K, F and N
Valid G codes are:
G0, G1, G2, G3, G17, G18, G19, G70, G71, G90, G91
If a code that is not in these groups is executed, the block time for that block will slow down.
F4 (Run) Main-Util-DNC-Run
F4 (Run) allows the same selections as F3 (Fast) for input modes. F4 (Run) does not have the
F10 mirror option. After the input mode has been selected and any blocks have been skipped, the
control selects the run screen (Main-Run) and the DNC program can be run similar to any other
program.
F9 (Verf) Main-Util-DNC-Verf
F9 (Verf) works identically as F4 (Run) mode. After the input mode has been selected and
blocks have been skipped, the control moves to the verify screen (Main-Verf) and the DNC
program can be verified similar to any other program.
Note: For F4 (Run) and F9 (Verf) RS-232 DNC mode, a search for a tool number or block
number can be done to start a program from a desired location. The program cannot be
reset to “first” after a search for a tool or block number..
The option for part/path/both is not available in DNC verify.
106