System information

SECTION TWO - FRONT PANEL OPERATION
F5 (Time) Main-Util-Info-Time
F5 (Time) displays the times and distances calculated when verifying a program. Timing
information is for 100% on the feedrate override for tool changes, spindle up to speed, block
stops, etc. Times are in hrs, min., sec. Distance is in inches or mm. Tool changes add 10 seconds
to the feed time.
This above screen shows timing information for the last program verified. The times displayed
assume the feedrate override is 100%. RUN gives the total time, FEED the milling time (G1, G2,
G3), and RAPID the G0 time. All times are in Hours:Minutes:Seconds. Distance is the total
distance moved in inches or millimeters.
F6 (Ram) Main-Util-Info-Ram
F6 (Ram) displays the following screen, which shows the contents of the RAM directory. F6 is
used mainly for diagnostic purposes. Programs that run special options on a machine are usually
stored in this directory.
111