System information

SECTION THREE - CONVERSATIONAL INPUT SCREENS
Event 16 of 16
End of Program
Spindle off [Yes]
Coolant off [Yes]
Z to Toolchange [Yes]
X Position (home relative)[ ]
Y Position (home relative)[ ]
---------------------------------------------------
The previous program will generate the following graphic.
Note: See page 316, Section 5 for more information on pocket clear.
F3 (Misc) Mill-Misc
See page 177, Section 3 for explanation of miscellaneous.
F4 (End) Mill-End
The F4 (End) screen is used to end a previously started mill cycle. An end mill cycle without a
start mill cycle, or a start mill cycle without an end mill cycle, will generate a syntax error when
the program is run or verified.
Common Error Codes for Milling Cycles
132