System information

SECTION THREE - CONVERSATIONAL INPUT SCREENS
Event 4 of 4
End of Program
Spindle off [Yes]
Coolant off [Yes]
Z to Toolchange [Yes]
X Position (home relative)[ ]
Y Position (home relative)[ ]
---------------------------------------------------
The following graphic illustrates the sample mill program using the round walls option on the
start mill cycle.
0° is a vertical wall; 90° is impossible. The round wall also has an option to use an end mill tool.
Cutter comp must be on to use the tapered walls option. The first Z depth should be the top of the
wall. The first pass is offset by the entire tool radius.
Note: See page 312, Section 5 for further information on rounded walls.
F5 (Pockt) Mill-Pockt
The F5 (Pockt) pocket mill selection brings up the following soft keys.
F1 (Setup) Mill-Pockt-Setup
The F1 (Setup) screen is used to set parameters necessary for the circular, rectangular and
polygon pocket routines. Setting parameters must be done prior to any pocket routines. The
manual pocket clear routine does not need the setup screen.
142